Air Hammer Operator in East Flat Rock, NC at Volt

Date Posted: 7/9/2018

Job Snapshot

  • Employee Type:
  • Job Type:
  • Duration:
    8 weeks
  • Date Posted:
  • Job ID:
  • Pay Rate
    $0.0 - $14.0/Hour
  • Contact Name
    Volt Branch

Job Description

 Air Hammer Operator 


Set up and utilize air-operated stripping tool to remove waste from printed die-cut sheets. 


• Sets up and utilizes air-operated stripping tool. 
• Removes scrap board from die-cut sheets. 
• Deposits scrap in proper recycling bins. 
• Stacks die-cut blanks on skids for gluer operations. 
• Exercises care in stacking carton blanks on skids to prevent carton mix-ups. 
• Utilizes a manual pallet jack to move skidded stock into position for stripping. 
• Maintains a clean and hazard free area at all times. 
• Informs the manager when supplies or parts are required. 
• Performs other job duties as assigned. 


• Must be able to read and comprehend documents such as safety rules, procedures and work instructions. 
• Must be able to meet and/or pass the minimum requirement on a mechanical test or have demonstrated mechanical aptitude through prior work experience. 
• Must be able to maintain good attendance. 
• Must be willing to work overtime as needed; significant overtime may be required during busy periods.
• Must be able to perform all essential functions of this job with or without reasonable accommodation. 


  • The physical demands described here are representative of those that must be met by an employee to successfully perform the essential functions of this position.
  • Reasonable accommodations may be made to enable individuals with disabilities to perform the essential job functions. 

  • Employee is required to: stand, walk, talk, see, and hear. 

This position has special vision requirements:

Close vision – clear vision at 20 inches or less. 
Peripheral vision – ability to observe an area that can be seen up and down and/or left and right while eyes are fixed on a given point. 
Eye–hand coordination – ability to guide the hands with the eyes. 

The noise level that is typical for the work environment of this position is: 
Very loud (examples: jack hammer or construction work).


2nd shift position

Volt is an EOE